Couth Mc 2000 Manual Pdf Mc-18 -

What are you trying to mark (steel, aluminum, plastic)? Are you trying to connect the controller to a PLC or PC ?

It seems there might be a small mix-up in the model names. The is a widely used industrial dot peen marking system, while the MC-18 usually refers to a specific series of micro-dosing units (like the MC18-Micro) rather than a COUTH marking head. couth mc 2000 manual pdf mc-18

Connect the 15-pin or 25-pin cable from the MC-18 head to the MC 2000 controller. Ensure the power is off during connection to avoid spiking the logic board. Controller Programming Basics What are you trying to mark (steel, aluminum, plastic)

: Typically up to 0.4mm for scribe units and up to 1mm for dot peen units. Controller Interface : The MC-2000T² Go to product viewer dialog for this item. The is a widely used industrial dot peen