Sinotimer Svp-916 Manual Pdf -

Navigate to P12 to view the last 5 fault codes. UH: Over-voltage fault. UL: Under-voltage fault. IH: Over-current fault.

The Sinotimer SVP-916 is an adjustable, 35mm DIN rail-mounted, self-resetting voltage and current protector designed for 230V single-phase electrical systems. It features dual LED displays, offering customizable over-voltage (221V–300V), under-voltage (150V–219V), and over-current protection with adjustable delay times. Read the full instruction manual on Amazon's Media Storage m.media-amazon.com Sinotimer Svp-916 Manual Pdf

Once voltage returns to the "Recovery Value" and stays stable for the "Fault Recovery Delay Time," the device automatically restores power. Navigate to P12 to view the last 5 fault codes

: You decide how much stress the system can take ( for high voltage, for low voltage). The Current Limit : You set the IH: Over-current fault

The SVP-916 supports 16 different ON/OFF settings (8 on/off pairs, usually labeled 1ON, 1OFF, 2ON, 2OFF... up to 8ON, 8OFF).

| Issue | Probable Cause | Solution (Without PDF) | | :--- | :--- | :--- | | | Dead internal battery | Plug the unit into live power for 24 hours to recharge. If still dead, replace battery (CR2032 or rechargeable Ni-MH soldered on board). | | Timer is not switching | Switch is in "ON" or "OFF" | Slide the switch to AUTO . | | Timer switches at wrong time | AM/PM confusion (24hr) | The SVP-916 uses 24-hour time. 2:00 PM = 14:00. Re-set the clock. | | Buttons don't beep/respond | Keypad is locked | Hold Clock for 5 seconds to unlock. | | Display shows "ERR" | Program overlap or invalid time (ON time same as OFF time) | Delete all programs using Reset button (paperclip hole) and reprogram. | | Timer turns on but not off | Missing OFF event | Edit programs. Ensure every "ON" has a corresponding "OFF" event for the same day. |